27 - 31 May
Our hydraulic veneer pack guillotines allow, with a single operation, the parallel cut of the veneer pack on both sides. The trimming of the veneer pack is carried out thanks to the simultaneous movement of the upper and lower knife: the first one is mounted on the fixed structure and the second one on the rear side of the mobile table.
A large pressure beam provides clamping the veneer pack during
the cutting operation and is the counter surface of the lower knife.
The machine is fitted with a rear longitudinal shoulder: the distance
from the lower knife is equal to the scrap and can be easily adjusted
by means of a push-button on the control panel.
The rear shoulder will position to the distance set by the rear knife.
The rapid positioning of the table will be effected by means of two
ballscrews and a brushless motor thus permitting a distance
between the knives equal to the width to be obtained. The pressure beam clamps the veneer pack, the upper knife cuts moving down to the table and the lower knife will move up against the pressure beam.
The machine permits to cut veneer tapes, paper or PVC, available on rolls, in order to obtain spools of narrower width.
The machine is supplied with:
- unwinding ...
VENEER WASTE COMMINUTING
It permits to comminute the veneer waste due to the veneer working, by cutting in small size pieces the long veneer strips.
It's a simple use press to mount drawerswith steel sides.Thanks to a practical system of locating stops, you can position in the machine the drawer components: the ...
Our machine allows you to obtain housing for hinges and the relevant
fittings to insert them. Thanks to this versatile device, even small companies
can save time, ...
This machine allows the simultaneous cross-cutting on both veneer pack sides and automatic measuring of veneer pack length. Accordingly programmed, it allows obtaining ...
The machine permits to obtain from the veneer pack any polygonal geometrical figure.
knife beam and pressure beam
The machine Mod. NG permits to finger joint two veneer strips,
already lengthwise trimmed.
The finger jointing is obtained by cutting with knife and counter-knife
Z650 - Z650/i
These models are suggested to joinery workshops or companies
where joining operation is not full-time required.
Thread heating is by electric resistance.
VENEER SPLICING MACHINE
MODEL LINEA 1000
for glue-spliced joints
This machine permits the longitudinal splicing of veneer sheets, the edges of which have been ...
Our machine permits high precision application of the glue on the edges of veneer bundles.The veneer is placed vertically, with one of the two trimmed sides on the ...
Cutting and trimming machine for veneer packs, sturdy electro-welded structure, high rigidity under bending and torsion stress, reduced overall wide dimensions thanks ...
Guillotines with pressurebeam and specially designed sturdy structure demanded by the power and the speedy required when cross-cutting veneer packs.
These machines are specially designed to offer, thanks to
the original constructive solutions, advantageous features to those
companies having ...