10 - 14 May
Saxwerk original hydraulic rotor is designed for round silos up to Ø 7000 mm. Design and layout vary depending on the material, diameter and output capacity.
The rotational movement is accomplished with mechanical drive and the speed is approximately 0.5 to 3.0 rpm. The rotor digging arms are in the start phase without pressure. The reason is to keep the starting moment as low as possible. After about 20-30 seconds from the start, the hydraulic unit is connected and with help of a pressure relief valve, the operating pressure is normally set at 30-50 bar. The rotor arms digs out from the center of the silo towards the silo wall and the loosened material is moved down through a chute to the discharge screw. If the pressure of the hydraulic arms are bigger than the set working pressure, then the arms folds away with the help of the pressure relief valve. When the working pressure has become normal, the digging arms starts working again.
Saxwerk original hydraulic rotor can be built into the silo from the diameter of 1500-7000 mm.
The hydraulic rotor can also be adapted to various diameters for installation in existing silos etc. This, for example to overcome the existing problems such as the bridging in silos. The silos can be made of steel, concrete or plastic
Saxwerk original sliding frame is available in three standards.
Wood and other bulk materials.
Sludge (municipal, fiber and bio-sludge)
The robust Push Floor is particularly suitable for heavy-wet and difficult to handle “non-flowing” material.
Delivery areas include dosing bins, ...
Saxwerks screw conveyors are suitable for all types of bulk materials such as coal and coal powder, fly- and bottom ash, REA gypsum, dewatered sludge, ...
Saxwerks Chain conveyors are suitable for the transport of shredded material such as wood chips, bark, peat, pellets, briquettes, coal and ash. Ash ...