27 - 31 May
High Precision Scale with X-Ray Technology
The HPS 5000 is the board scale with the H-factor! With high resolution, each mm² of the board surface is measured. Due to the overall measurement, any deviations, fluctuations and tolerance deviations are shown immediately and can be retrieved via an OPC interface. Based on an automatic calibration, which is also independent of the production process, the measured value is reliable. A reliable and resource-friendly production is ensured.
Resulting from the measurement philosophy, the longitudinal and the crosswise measurement of the boards becomes another useful advantage of the system. Similar to the CS 5000, there are only small installation dimensions required, and the production speed does not impair the measuring result. "H" stands for high accuracy, high availability and immediate amortisation - these are the features of the HPS 5000.
Particleboard is the wood based panel type which is used the most worldwide. Especially for the contruction of furniture and interior work, the panels, that consist ...
Due to their various capabilities in wooden and furniture constructions, MDF panels (medium density fibreboard) are a derived timber product, the demand of which ...
Foreign objects and particles of high density, such as metal pieces, hot spots or fibre lumps, can cause severe damage to production Equipment.
Contaminated wood chips can cause numerous problems in downstream production processes. Nails can damage the steel belt, and rubber particles
FIBERVIEW - Taking Samples from the Mat Belongs to the Past
GreCon FIBERVIEW allows an economical and objective assessment of the fibre quality in the running ...
An even material distribution of the mat is an important pre-condition for a good panel quality. High fluctuations lead to waste of material, loss of quality and ...
The intensity of the ultrasound signal that penetrates a wood based panel provides valuable information on the panel parameters.
Substandard ultrasound values ...
Drying material is expensive, but essential.
If the moisture of the raw material is too high, there will be problems in downstream processes. If it is too low, ...
The weight per unit area gives information on the amount of the material used.
If the weight per unit area is too high, valuable material will be wasted. If it ...
The raw density profile is an extremely important parameter in the production of fibreboard.
If the profile does not correspond to the optimum shape, this will ...
A high surface quality of panel-shaped materials is pre-condition for a high-quality product. This also applies to materials that are coated.
Temperature & Gas Pressure Measurement Wireless in Your Hot Press
Optimise your pressing process by measuring the development of gas pressure and mat ...
The formaldehyde emission of wood based panels is subject to legal regulations.
High emissions are unacceptable and can cause serious quality defects. With the ...
For the production of wood based panels, fluctuations in panel thickness and deviations from nominal values reduce quality. Your customers will identify these as ...
Close to the heart of the action in the hot press: GreCon added EASYLOG to the CONTILOG product family to measure gas pressure and temperature. This smaller chip ...