27 - 31 May
On-site phone: +49 511 89497001
On-site fax: +49 511 89597001
During the LIGNA 2017, PALLMANN presents its newest Disc Chipper, Type PHS 36 in hall 26, booth E28. The size and the throughput rate of this disc chipper complete ...
Pallmann offers complete system solutions for the size reduction and preparation of wood for the panel industry. These systems have been successfully operating in ...
The quality of the chips is an important prerequisite for the efficient and trouble-free operation of an MDF-system and constant board quality. PALLMANN has developed ...
The Double Stream Mill, series PSKM is used for the production of surface layer flakes or wood flour from course material or middle layer flakes of wood or annual ...
The Hammer Mill, series PHMS is used for the economical preparation of chips from round-, residual or waste wood and annual plants into quality flakes for middle- ...
PALLMANN has developed the Long Log Flaker, series PZU for the production of quality flakes / strands with a low percentage of fines, for the production of OSB-boards.
The Pressurized Refiner is used for the preparation of chips into high quality flakes for MDF-board production and for the production of door leafs and insulting ...
The Drum Debarker, type PDD was developed for the economical and gentle debarking of logs. The Drum Debarker is not only used in the MDF-industry but also in all ...
The standard feed material for the production of flakes in the particle board industry are chips produced from round wood, industrial wood- and saw mill waste but ...
The Knife Ring Flaker, series PZKR is used for dry- and wet preparation of chips into flakes at best possible consistent flake geometry and -quality. Flakes so produced ...
Pallmann Maschinenfabrik is one of the leading manufacturers of size reduction machines and - systems as well as complete wood yard installations for the wood based panel industry, for the preparation of biomass, for waste paper recycling and for the production of pulp. We deliver size reduction technology and systems for the following fields of application:Particle board -Drum Chippers -Knife Ring Flakers -Sharpening and Setting Robots -Rotor Debarkers and Drum Debarkers-Double Stream Mills -Hammer Mills etc.Annual plants-Depithers -Hammer mills OSB-strands-Long Log Flakers -Wood yard installations MDF-fibres-Pressurized Refiner Systems -Chip washing systems-Wood yard installations Waste wood recyclingPulp / Paper industry-High consistency (HC)-RefinerWaste paper recycling -Single shaft shredders-Hammer Mills-Dosing equipment for chemicals-Whirl Mills, ATEX conformPellet industryPower plants-Biomass preparation-Pellet reduction
Phone: +49 6332 802 0
Fax: +49 6332 802 541
Mr. Hartmut Pallmann, Mr. Stefan Wissing